AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Scaricare il pdf (Pagina 62)

Appendix A - Telnet (Terminal) Commands

Instruction Manual - Solecis Digital Switchers

Telnet Commands (Cont.)

Command Description

SET ETHERNET MODE This command sets the current LAN configuration settings per new mode.

Syntax:

SET ETHERNET MODE <newmode>

Values for newmode are:

auto

10 full, 100 full, 10 half, or 100 half

Note: This command requires a reboot to enable new settings.

Examples:

set ethernet mode auto

set ethernet mode 100 full

SET FRIENDLY Set the device’s friendly name for NDP to <name>.

Syntax:

SET FRIENDLY <name>

• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be

truncated.

• The value is stored in non-volatile memory.

• If no value specified, an automatic name consisting of AMX, the product name, and

serial number will be used.

Note: This command requires a reboot to enable new settings.

SET IP Sets the IP configuration of a specified device.

Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask, and Gateway IP

Address.

Important: Host Names may only contain ASCII letters “a” through “z” (not case-

sensitive), digits “0” through “9”, and the hyphen (“-”).

Note: Note: DHCP implies “DHCP with link-local fallback”.

Note: Note: For NetLinx Masters, the Host Name can only consist of alphanumeric

characters.

• Enter Y (yes) to approve/store the information on the Master.

• Enter N (no) to cancel the operation.

Note: This command requires a reboot to enable new settings.

Example:

>SET IP

--- Enter New Values or just hit Enter

to keep current settings ---

Enter Host Name: DXL-RX-36d0110

Enter IP type. Type D for DHCP or S for Static IP and

then Enter: DHCP

You have entered: Host Name DXL-RX-36d0110

Type DHCP

Is this correct? Type Y or N and Enter -> y

Settings written. Device must be rebooted to enable

new settings.

Note: The switcher can also be set to Static IP or DHCP Mode via the front panel ID

Pushbutton.

SET LOCATION Sets the location parameter for NDP.

Syntax:

SET LOCATION <location>

Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be

truncated.

Note: This command requires a reboot to enable new settings.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Commenti su questo manuale

Nessun commento

AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Pagina 62

Commenti su questo manuale

Prodotti e manuali riguardandi Networking AMX AXP-AI8 ANALOG 8-INPUT BOARD