AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Scaricare il pdf (Pagina 33)

Wiring Specifications

Instruction Manual - Solecis Digital Switchers

Important Twisted Pair Cabling Requirements and Recommendations

The following requirements and recommendations apply to cabling DXLink (RJ-45) connectors:

DXLink cable runs require shielded category cable (STP) of Cat6 (or better).

DXLink twisted pair cable runs for DXLink equipment shall only be run within a common building.*

DXLink delivers 10.2 Gb/s throughput over shielded category cable. Based on this bandwidth requirement,

we recommend following industry standard practices designed for 10 Gigabit Ethernet when designing and

installing the cable infrastructure.

The cables should not be longer than necessary to reach the end-points. We recommend terminating the cable

to the actual distance required rather than leaving any excess cable in a service loop.

For more details and helpful cabling information, reference the white paper titled "Cabling for Success with DXLink"

available at www.amx.com

or contact your AMX representative.

* "Common building" is defined as: Where the walls of the structure(s) are physically connected and the structure(s)

share a single ground reference.

AXLINK KEYPAD Port

The AXLINK KEYPAD port allows the switcher to provide data and power to up to two external AxLink keypads.

FIG. 25 displays the AxLink port on the SDX-410-DX.

FIG. 25 AXLINK KEYPAD Port (SDX-410-DX)

The green AXLINK KEYPAD LED indicates AxLink data activity:

Off - No power, or the switcher is not functioning properly.

1 blink per second - Normal operation.

3 blinks per second - AxLink bus error. Check all AxLink bus connections.

Note: The AXLINK KEYPAD LED is located on the front panel of the SDX-410-DX and SDX-810-DX while the AxLink

port itself is located on the rear panel. On the SDX-510M-DX, both the port and LED are located beside each other on

the front panel.

The AxLink port can be used to supply power to AxLink keypads. The port is capable of providing at least 2 Amps of

12V power up to a maximum distance of 225ft. (68.58m).

FIG. 26 provides wiring requirements for the AxLink connector:

FIG. 26 Mini-Phoenix connector wiring diagram (direct data and power)

Top view

To the switcher’s

AxLink/PWR connector

To the external AxLink device

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

Nessun commento

AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Pagina 33