AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Scaricare il pdf (Pagina 27)

Device Connectors

Instruction Manual - Solecis Digital Switchers

USB (SDX-510M-DX only)

The two type-A USB connectors on the front panel are used to connect peripheral devices to the SDX-510M-DX

(FIG. 16). You can use the type-B USB connector to connect the switcher to a PC and emulate keyboard and mouse

commands from a DXLink Receiver.

Note: The Type-A USB connectors are reserved for future use.

FIG. 16 displays the USB ports.

FIG. 16 USB ports

Power

This section describes the power options for the Solecis Digital Switchers.

Note: Apply power to the unit only after installation is complete.

INPUT POWER Connector (SDX-410-DX and SDX-810-DX only)

The INPUT PWR connector is a 2-pin 3.5mm screw terminal connector with retention screws. This power connector is

available on the SDX-410-DX and SDX-810-DX.

FIG. 17 INPUT PWR connector

Optimal performance requires use of one of the following AMX power supplies (not included):

PSR4.4, 13.5 VDC, 4.4 A Power Supply with 3.5mm Phoenix Connector with Retention Screws (FG423-46)

PSN6.5, 13.5 VDC, 6.5 A Power Supply with (3) 3.5mm Phoenix Connectors (FG423-41)

AC Power Connector (SDX-510M-DX only)

The SDX-510M-DX receives power through a 110-240VAC, 47-63 Hz connector. FIG. 18 displays the power switch and

connector for the SDX-510M-DX.

FIG. 18 Power Connector/Switch/Fuse

Type-A USB

Type-B USB

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 69 70

Nessun commento

AMX AXP-AI8 ANALOG 8-INPUT BOARD Manuale delle Istruzioni Pagina 27