AMX DESIGN XPRESS V 1.5 - ON SITE INSTALLER GUIDE Guida di Installazione Scaricare il pdf (Pagina 15)

TIBCO ActiveMatrix BPM Installation and Configuration

Installation Overview

The installation and configuration of the product involves the following steps:

1. Complete the pre-installation tasks which includes fulfilling the hardware and

software requirements, and setting up and configuring all the required third

party software.

2. Install TIBCO ActiveMatrix BPM. Depending on the architecture, the

installation process may involve repeating the basic installation on different

machines in one of the installation modes.

3. Configure the product using TIBCO Configuration Tool (TCT). Depending on

the architecture, you may need to configure the installation on more than one

machine.

4. Perform the post-installation tasks.

Before performing the pre-installation or the actual installation process, you must:

• determine the architecture for your system based on your requirements. For

example, you can choose to have a highly available, fault tolerant (HA-FT)

system, a distributed system, or a basic system.

• decide the approach for the installation process - GUI, console, or silent

installation.

The above factors decide the tasks that need to be performed to install and

configure a BPM system to suit your requirements.

Installation Modes

Three installation modes are available: GUI, console, and silent.

GUI Mode

In the GUI mode, the installer presents panels that allow you to make choices

about product selection, product location, and so on. To invoke the installer in

GUI mode, double-click the executable.

In the GUI mode only, the TIBCO Configuration Tool runs after the installer

completes if the checkbox Launch TIBCO Configuration Tool on the Summary

screen is not unchecked. See Running the TIBCO Configuration Tool for details.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 224 225

Nessun commento

AMX DESIGN XPRESS V 1.5 - ON SITE INSTALLER GUIDE Guida di Installazione Pagina 15