Amx NetLinx Integrated Controllers NI-700/900 Manuale Utente

Hardware Reference GuideNetLinx Integrated ControllersNI-700/900NetLinx Integrated ControllersLast Revised: 5/13/2008

Introduction6NI-700 & NI-900 Hardware Reference GuideNI-900 SpecificationsDimensions (HWD): • 1.58" x 5.54" x 5.12" (4.01 cm x 14.1

Introduction7NI-700 & NI-900 Hardware Reference GuideNI-900 Specifications (Cont.)Rear Panel Components (Cont.):IR RX (Port 6)• 4-pin 3.5 mm mini-

Introduction8NI-700 & NI-900 Hardware Reference GuideNI-900 Port Assignment And Functionality NI-900 Specifications (Cont.)Rear Panel Components (

Introduction9NI-700 & NI-900 Hardware Reference GuideNI-900 On-Board Memory SpecificationsThere are two variations on the NI-900, with different m

Introduction10NI-700 & NI-900 Hardware Reference Guide

Installation11NI-700 & NI-900 Hardware Reference GuideInstallationDevice:Port:System (D:P:S)A device is any hardware component that can be connect

Installation12NI-700 & NI-900 Hardware Reference Guide6. Align the ends of the AC-RK with the screw openings along the sides of the equipment rack

Connections and Wiring13NI-700 & NI-900 Hardware Reference GuideConnections and WiringSetting the Configuration DIP Switch (for the Program Port)P

Connections and Wiring14NI-700 & NI-900 Hardware Reference GuideWorking With the Configuration DIP Switch1.Disconnect the power supply from the 2-

Connections and Wiring15NI-700 & NI-900 Hardware Reference GuideModes and Front Panel LED Blink PatternsThe following table lists the modes and bl

AMX Limited Warranty and DisclaimerThis Limited Warranty and Disclaimer extends only to products purchased directly from AMX or an AMX Authorized Part

Connections and Wiring16NI-700 & NI-900 Hardware Reference GuideThe AXlink port can be used to supply power to downstream AXlink-compatible device

Connections and Wiring17NI-700 & NI-900 Hardware Reference GuideWiring A Power ConnectionTo use the 2-pin 3.5 mm mini-Phoenix connector with a 12

Connections and Wiring18NI-700 & NI-900 Hardware Reference GuideUsing the 4-pin Mini-Phoenix Connector For Data With External PowerTo use the 4-pi

Connections and Wiring19NI-700 & NI-900 Hardware Reference GuideThe table below provides information about the connector pins, signal types, and s

Connections and Wiring20NI-700 & NI-900 Hardware Reference GuideInput/Output (I/O) Port: Connections and WiringThe I/O port responds to either swi

Connections and Wiring21NI-700 & NI-900 Hardware Reference GuideIR/Serial Port: Connections and WiringYou can connect only one IR- or Serial-contr

Connections and Wiring22NI-700 & NI-900 Hardware Reference GuideFIG. 9 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and

Connections and Wiring23NI-700 & NI-900 Hardware Reference GuideEthernet Ports Used By the Integrated ControllerEthernet Port DescriptionsPort typ

Connections and Wiring24NI-700 & NI-900 Hardware Reference Guide

Connections and Wiring25NI-700 & NI-900 Hardware Reference Guide

Table of ContentsiNI-700 & NI-900 Hardware Reference GuideTable of ContentsIntroduction ...

5/08 ©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX. AMX reserves the right to alter specifications without no

iiNI-700 & NI-900 Hardware Reference GuideTable of Contents

Introduction1NI-700 & NI-900 Hardware Reference GuideIntroductionNI-700 OverviewThe NI-700 NetLinx Integrated Master Controller can be programmed

Introduction2NI-700 & NI-900 Hardware Reference GuideNI-700 SpecificationsDimensions (HWD): • 1.58" x 5.54" x 5.12" (4.01 cm x 14.1

Introduction3NI-700 & NI-900 Hardware Reference GuideNI-700 Specifications (Cont.)Rear Panel Components (Cont.):IR RX (Port 5)• 4-pin 3.5 mm mini-

Introduction4NI-700 & NI-900 Hardware Reference GuideNI-700 Port Assignment And Functionality NI-700 On-Board Memory SpecificationsThere are two v

Introduction5NI-700 & NI-900 Hardware Reference GuideNI-900 OverviewThe NI-900 is the first NetLinx device to be Duet-compatible straight out of t