AMX DESIGN XPRESS V 1.5 - PROGRAMMER GUIDE Guida Utente Scaricare il pdf (Pagina 111)

KwikNet System Configuration

DAK

PPP IP Address Definition (continued)

Edit: IP Address

You must select the Edit: IP Address radio button to define the network's IP address and

related parameters.

IP Version

Select the combination of IPv4 and IPv6 protocols that this network interface supports.

IPv4 Support only IPv4.

IPv6 Support only IPv6.

All (v4 and v6) Both IPv4 and IPv6 must be supported.

If you select IPv6, be sure to configure your KwikNet Library to include IPv6 support. To

do so, check the box labeled "Support IPv6" on the IPv6 property page. Failure to do so

will result in a compilation error when you attempt to compile your KwikNet Library. The

error will inform you that your library does not include support for IPv6.

Packet Forwarding

Select the type of packet forwarding that this network interface supports.

Disabled Forwarding of packets is not allowed on this interface.

Unicast only Support forwarding of IPv4 or IPv6 unicast packets.

Unicast + Dir. Broadcast Support forwarding of IPv4 or IPv6 unicast packets

and IPv4 directed broadcast packets.

IP Address

Enter the IP address of the network interface. This must be a unique, valid IP address

which can be used to identify the host computer attached to this network interface. Enter

0.0.0.0 if the network IP address is to be assigned or negotiated at runtime.

Remote IP Address

Enter the proposed IP address for the foreign host to which the PPP network interface is

to be connected. If an address is provided, the network driver will attempt to negotiate

with the peer to establish the specified address as the peer's IP address. If the negotiation

fails, the network will accept the address provided by the peer. Enter 0.0.0.0 if the

proposed remote IP address is to be assigned at runtime or if there is no desire to propose

an IP address for use by the peer.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 315 316

Nessun commento

AMX DESIGN XPRESS V 1.5 - PROGRAMMER GUIDE Guida Utente Pagina 111