AMX Distributed Audio Controllers Delta Series Specifiche Pagina 87
- Pagina / 239
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Chapter 5 Parameters|VFD-B Series
5-30 Revision July 2008, BE16, SW V4.08 & V5.00
1-05 1-03 1-01
1-06
1-04
1-02
1-00
1-07
1-08
V
/f Curve
Voltage
Frequency
Output Frequency
Lower Limit
Output Frequency
Upper Limit
The limit of
Output
Frequency
Mid-point
Freq.
Maximum
Output
Frequency
Maximum
Output
Voltage
Mid-point
Voltage
Minimum
Output
Voltage
Minimum
Output
Freq.
Maximum Voltage
Frequency
(Base Frequency)
01 - 08 Output Frequency Lower Limit Unit: 1
Settings 0 to 100% Factory Setting: 0
The Upper/Lower Limits are to prevent operation errors and machine damage.
If the Output Frequency Upper Limit is 50Hz and the Maximum Output Frequency is 60Hz, the
Output Frequency will be limited to 50Hz.
If the Output Frequency Lower Limit is 10Hz, and the Minimum Output Frequency (Pr.01-05) is
set to 1.0Hz, then any Command Frequency between 1.0-10Hz will generate a 10Hz output
from the drive.
This parameter must be equal to or less than the Output Frequency Upper Limit (Pr.01-07).
The Output Frequency Lower Limit value = (Pr.01-00 * Pr.01-08) /100.
01 - 09 Acceleration Time 1 (Taccel 1) Unit: 0.1/0.01
01 - 10 Deceleration Time 1 (Tdecel 1) Unit: 0.1/0.01
01 - 11 Acceleration Time 2 (Taccel 2) Unit: 0.1/0.01
01 - 12 Deceleration Time 2 (Tdecel 2) Unit: 0.1/0.01
01 - 18 Acceleration Time 3 (Taccel 3) Unit: 0.1/0.01
01 - 19 Deceleration Time 3 (Tdecel 3) Unit: 0.1/0.01
01 - 20 Acceleration Time 4 (Taccel 4) Unit: 0.1/0.01
01 - 21 Deceleration Time 4 (Tdecel 4) Unit: 0.1/0.01
Settings 0.01 to 3600.0 sec Factory Setting: 10.0
Factory setting for models of 30hp (22kW) and above is 60sec.
- Preface 4
- WARNING! 5
- 8
- Chapter 1 Introduction 10
- 1.1.4 Drive Frames 11
- 1.2 Appearances 11
- 1.3.1 Remove Keypad 13
- 1.3.2 Remove Front Cover 15
- 1.4 Lifting 16
- 1.5 Storage 17
- 2.1 Ambient Conditions 18
- 2.2 Installation 18
- Air Flow 19
- 2.3 Dimensions 20
- UNIT : mm(inch) 23
- R6.5[0.25] 26
- 2.4 Wiring 29
- 2.4.1 Basic Wiring 30
- 0~10VDC/2mA 31
- 0~10VDC/2 mA 33
- 2.4.2 External Wiring 35
- DC reactor 37
- 2.4.4 Control Terminals 38
- AVI circuit 40
- AVI/ACI/AUI 41
- 2.4.5 Main Circuit Terminals 43
- R/L1 S/L2 T/L3 44
- To connect 6 AWG (13.3 mm 45
- W/T3V/T2 46
- (173in -lbf) 47
- S/L2 T/L3 U/T1 V/T2 2/T3 48
- Chapter 3 Start Up 50
- VFD-PU01 54
- GO START 56
- Chapter 5 Parameters 58
- RUN/STOP 76
- 00-08 00-07 84
- Disable S curve 90
- Enable S curve 90
- Example: 104
- MI2=08 MI1=07 113
- Accel/decel time 1 OFF OFF 113
- Accel/decel time 2 OFF ON 113
- Accel/decel time 3 ON OFF 113
- Accel/decel time 4 ON ON 113
- Unit: 1 115
- 14 13 12 11 10 119
- CAUTION! 138
- ( 7.N.2) 141
- ( 7.E.1) 141
- Unit: 0.01 153
- Unit: 0.1 154
- Fault Code Information 164
- 6.2 Reset 167
- Chapter 7 Troubleshooting 168
- 7.2 Ground Fault 169
- 7.3 Over Voltage (OV) 169
- 7.4 Low Voltage (Lv) 170
- 7.5 Over Heat (OH) 171
- 7.6 Overload 171
- 7.8 Phase Loss (PHL) 172
- 7.9 Motor cannot Run 173
- 7.14 Environmental Condition 176
- Appendix A Specifications 184
- General Specifications 186
- Enviromental Conditions 186
- Appendix B Accessories 188
- VFD Series 190
- R3.3 [R0.13] 194
- B.2.1 Dimensions 199
- Order P/N: 10TDT1W4C 202
- Order P/N: 26TDT1W4C 202
- Order P/N: 50TDS4W4C 203
- Order P/N: 100TDS84C 203
- Order P/N: 200TDDS84C 204
- Order P/N: 150TDS84C 204
- Order P/N: 180TDS84C 205
- Order P/N: 20TDT1W4D 205
- Order P/N: 26TDT1W4B4 206
- B.3 PG Card (for Encoder) 207
- B.3.1 PG02 Installation 207
- FSW2 FSW1 211
- B.3.2 PG03 212
- B.3.2.1 Installation 212
- B.4 Remote Controller RC-01 217
- B.6 AC Reactor 219
- Zero Phase Reactor 224
- B.11 PU06 229
- B.11.3 Operation Flow Chart 230
- C.1 Capacity Formulas 233
- )(_____103 234
- C.2 General Precaution 235
- Load duty-cycle 236
Bosch LTC-2915-91 manuály
Uživatelské manuály a uživatelské příručky pro Televizory a monitory Bosch LTC-2915-91.
Poskytujeme 1 manuály pdf Bosch LTC-2915-91 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commenti su questo manuale